-
DB-1300-DB-1800
Three layer film blowing machine with horizontal haul off
-
3DB-A
Three layer film blowing machine
-
ABA
film blowing machine
-
2DB-A
Two layer film blowing machine
-
DB-B50/55/60/65
Single layer film blowing machine
-
DB-A45-700/A50-900
Single layer film blowing machine with printer
-
DB-350x2/450x2
T-shirt bag making machine
-
DB-600-1000
Side sealing bag making machine
Film blowing machine rewinding failure
When the film blowing machine is blowing film, some friends encounter uneven rewinding of the film blowing machine, the blown film is naturally sucked together, and the film has static electricity. Many people are confused about this problemHere we have sorted out some solutions
Symptom 1: What should I do if the film blowing machine is not even when rewinding?
Symptom 2: The film blown out of the plastic film is naturally sucked together and has static electricity.
Symptom 3: Sometimes there is no static electricity, and sometimes the static electricity is very strong. The hair under the film can stand up.
In fact, in many cases, it may be caused by static electricity.
The rewinding is a multi-layer winding structure. The static electric field energy gathered on each layer is not large, and the static electricity on each layer may be only a few hundred volts; when hundreds or even thousands of layers of film are wound together, the voltage and energy of the static electric field are very large, the voltage reaches more than 20KV, and in severe cases, it is as high as more than 100KV.
Solution: Install a static eliminator